Cisco 3750G - Catalyst Integrated Wireless LAN Controller Руководство по началу работы - Страница 35
Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Cisco 3750G - Catalyst Integrated Wireless LAN Controller. Cisco 3750G - Catalyst Integrated Wireless LAN Controller 49 страниц. Integrated wireless lan controller switch
Также для Cisco 3750G - Catalyst Integrated Wireless LAN Controller: Руководство по конфигурации (40 страниц)
• Did you wait 30 seconds after you connected
the switch and the PC before you entered the
IP address in your browser?
• Did you enter the wrong address in the
browser, or is there an error message?
Resetting the Switch
This section describes how to reset the switch by rerunning Express Setup. These are reasons why you
might want to reset the switch:
• You installed the switch in your network and cannot connect to it because you assigned the
incorrect IP address.
• You want to clear all configuration from the switch and assign a new IP address.
• You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press
the Mode button (which means that the switch is already configured with IP information).
Caution
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue
holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch
reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP information by using
Express Setup as described in the "Running Express Setup" section on page 4.
If not, wait 30 seconds, re-enter 10.0.0.1 in the
browser, and press Enter.
If yes, re-enter 10.0.0.1 in the browser, and press
Enter.
35