Cisco 5509 - Catalyst Chassis Switch Руководство по установке - Страница 24
Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель Cisco 5509 - Catalyst Chassis Switch. Cisco 5509 - Catalyst Chassis Switch 34 страницы. Wireless controller
Также для Cisco 5509 - Catalyst Chassis Switch: Руководство по быстрой установке (17 страниц)
Печатать страницу
Using the Startup Wizard
If the controller passes the power-on self test, the bootup script runs the Startup Wizard, which prompts
Step 6
you for basic configuration input.
Using the Startup Wizard
Before you can use the startup wizard, you must obtain the information discussed in the
and Information" section on page
The available options appear in brackets after each configuration parameter. The default value appears
Note
in all uppercase letters.
Press the hyphen key if you need to return to the previous command line.
Note
To configure the controller for basic operation using the Startup Wizard, follow these steps:
When prompted to terminate the AutoInstall process, enter yes. If you do not enter yes, the AutoInstall
Step 1
process begins after 30 seconds.
Note
Enter the system name, which is the name you want to assign to the controller. You can enter up to
Step 2
32 ASCII characters.
Enter the administrative username and password to be assigned to this controller. You can enter up to 24
Step 3
ASCII characters for each. The default administrative username and password are admin and admin,
respectively.
Step 4
If you want the controller's service-port interface to obtain an IP address from a DHCP server, enter
DHCP. If you do not want to use the service port or if you want to assign a static IP address to the
service-port interface, enter none.
Note
If you entered none in
Step 5
two lines.
Enable or disable link aggregation (LAG) by choosing yes or no.
Step 6
Enter the IP address, netmask, default router IP address, and optional VLAN identifier (a valid VLAN
Step 7
identifier or 0 for an untagged VLAN) for the management interface.
Cisco 5500 Series Wireless Controller Installation Guide
24
The AutoInstall feature downloads a configuration file from a TFTP server and then loads the
configuration onto the controller automatically.
The service-port interface controls communications through the service port. Its IP address must
be on a different subnet from the management interface. This configuration enables you to
manage the controller directly or through a dedicated management network to ensure service
access during network downtime.
Step
4, enter the IP address and netmask for the service-port interface on the next
8.
"Required Tools
78-18998-01