Accuspray VMX Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Воздушный компрессор Accuspray VMX. Accuspray VMX 20 страниц. Portable compressor hvlp system

Печатать страницу

Daily Maintenance

Your Accuspray HVLP Gun is made from cast

aluminum, and it contains aluminum components.

Certain solvents containing Methylene Chloride and

Trichloromethane are not chemically compatible with

aluminum. If you are in doubt whether a coating or

solvent is compatible, read the Material Safety Data

Sheet, or contact your material supplier.

It is very important to clean your gun and cup after

every use. The fluid passage can be cleaned by

adding a small amount of solvent to a clean cup,

pressurizing the cup, and triggering the gun. Do this

with the air cap removed so you may recapture the

spent solvent for proper disposal.

The air cap should be cleaned by soaking, or by

using a soft brush. Never use a hard tool that may

damage the air cap holes. Clean the air cap holes

with a wooden tooth pick or pipe cleaner. The

smallest amount of damage to the air cap holes can

effect the spray pattern.

Your gun and cup may be cleaned in a gun washer.

Limit the time in the gun washer to a maximum of 5

minutes. Some solvents may enter the through the

air inlet fitting. This will not damage the gun, and the

excess solvent may be blown out with air.

Lubrication

After every cleaning of the gun, you should lubricate

the moving components. Lubricate with Accuspray

Gun Lube P/N 91-170.

Component Replacement

With regular cleaning and lubrication, complete

disassembly of your gun should seldom be required.

800-618-6860 or 440-498-9677 Fax: 440-498-9815

- 9 -

V M X

Owners Manual

Maintenance

When it becomes time for a complete overhaul, or a

part requires replacement, please follow these

instructions:

General

Close your air source down. Remove the air hose

from the gun. Dispose of any unused paint, flush

and clean the gun.

Atomizing Set

With the retaining ring and air cap removed, pull and

hold the trigger, unscrew the fluid nozzle using your

Accuspray Gun Wrench and remove the fluid nozzle.

Release the trigger and unscrew the needle tip with

your fingers. Remember to retract the needle when

re-installing the fluid nozzle.

To remove the needle shaft, unscrew and remove

the needle adjustment screw and the needle

adjustment spring. Pull the needle out of the gun

with your fingers. If the needle does not pull out

freely, loosen the packing nut. Your gun wrench will

accomplish this with the trigger still attached to the

gun.

Trigger Removal

Locate the 2 E-clip's on the side of the trigger. Slide

them off with a flat-blade screwdriver. The trigger

pivot pin (upper), and the trigger pin (lower) will now

slide out. The trigger is now free to be removed.

Packing Nut Spacer and Packing

Unscrew and remove the needle adjustment screw

and the needle adjustment spring. Pull the needle

out of the gun with your fingers. If the needle does

not pull out freely, loosen the packing nut. Remove

the packing nut with your gun wrench. The

compression spring, spacer, needle guide, and seal

should fall freely from gun. If you experience

difficulty with removal, remove trigger pin and firmly

tap the rear of the gun on a block of wood. Then

remove the seal with an o-ring pick or similar narrow

instrument.