Cisco C-series Nexus 5020 Руководство по установке оборудования

Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Переключатель Cisco C-series Nexus 5020. Cisco C-series Nexus 5020 19 страниц. Replacing an i/o module nexus 5000 series
Также для Cisco C-series Nexus 5020: Технические характеристики (3 страниц), Информационный лист (23 страниц), Примечание к выпуску (26 страниц), Примечание к выпуску (3 страниц), Руководство (11 страниц)

Cisco C-series Nexus 5020 Руководство по установке оборудования

Replacing Components

This chapter describes how to remove and install components for the Cisco Nexus 5500 Platform switch
or the Cisco Nexus 5000 Platform switch.
This section includes the following sections:
To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by
Caution
the carrier edges only.
Replacing an I/O Module for a Cisco Nexus 5548 Switch
To replace an I/O module with another I/O module (Layer 2 I/O module or layer 3 I/O module) you must
remove the right fan module and then pull the I/O module out using the handle of the left fan module,
which is installed in the middle of the I/O module. You then install the replacement I/O module and fill
its fan module slots with the fan modules from the original I/O module.
If the module includes the product ID on the front, it is a Layer 3 I/O module (product ID N55-D160L3
Note
or N55-D160L3-V2). The N55-D160L3-V2 uses a newer version of the Layer 3 ASIC and enables higher
table sizes in a future software release from 8K host entries to 16K host entries or from 4K multicast
routes to 8K multicast routes (IPv4). The Layer 2 module (product ID N55-DL2) does not include the
product ID on the front.
Replacing an I/O Module for a Cisco Nexus 5548 Switch, page 4-1
Replacing Expansion Modules, page 4-5
Replacing or Installing Power Supplies, page 4-8
Replacing a Fan Module, page 4-13
Removing the Cisco Nexus 5500 Platform Chassis or the Cisco Nexus 5000 Platform Chassis,
page 4-17
C H A P T E R
Cisco Nexus 5000 Series Hardware Installation Guide
4
4-1