BYOGuitar.com JEM Инструкция по сборке Руководство - Страница 6

Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Музыкальный инструмент BYOGuitar.com JEM. BYOGuitar.com JEM 11 страниц.

Attaching the Neck to the Body

Temporarily attach the neck so you can locate the bridge. If the holes are tight, use some soap or wax

on the screw beforehand and it will drill in easier. The screws may go into the neck very tight. Be very

careful not to snap the screw! Get the neck screws snug, but not completely tightened. This will allow

some slight adjustment when you align the neck with the bridge.

Installing the tuners

Each tuner consists of the tuner, washer, and a threaded bushing. The tuners are attached to the

headstock with a small wood screw that attaches between the tuners.

To install the tuners:

1. Place the six tuners into the holes on the back of the headstock. The holes may need to be widened

with a peghead reamer or a round file. DO NOT widen the holes too much—the tuners should fit snug.

2. Slide a washer over the tuner shaft and screw the threaded bushing onto the tuner.

3. Align the tuners perpendicular to the edge of the headstock and parallel to each other. Use a strip of

masking tape to secure their position on the headstock.

4. Using a 1⁄16" drill bit in a drill press, drill 3⁄8" deep holes into the headstock.

⁄

Note— Drilling the holes deeper than 3

8" could result in drilling out through the front face of the

headstock. Use a depth stop or tape wrapped around the drill bit at the correct depth as an indicator.

5. Secure the machine heads to the guitar headstock with the tap screws.

The locking nut is positioned at the top of the neck. Place the locking nut and metal shim in the slot with

the higher edge against the end of the fingerboard. Making sure the nut is centered in the slot, attach it

with two screws.

Gently tap the posts into place using a piece of wood on top of the post so you don't damage it. If you

feel too much resistance, stop, and make sure the hole is big enough.

Install the spring hook in the front of the bottom cavity. Make sure it's centered in the cavity. You don't

want the screws all the way in. About half way is good. This allows you to adjust the tension of the

springs by either screwing them in more or less.

Place the trem in place and attach the springs.