Cisco Catalyst 3040 Руководство по началу работы - Страница 19

Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Cisco Catalyst 3040. Cisco Catalyst 3040 37 страниц. Catalyst blade switch for fsc

Печатать страницу

no shutdown

ip address 10.0.0.1 255.255.255.0

interface GigabitEthernet0/1

interface GigabitEthernet0/2

. . . (output truncated)

interface GigabitEthernet0/16

end

Step 10 These choices appear. Enter 2, and then press Return.

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots,

save it in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Step 11 If you plan to set up more than one blade switch, enter Ctrl-Q to return to the Console

Redirect Switch Blade menu, and choose the next blade switch. When you have set up all of

the blade switches, enter 0 on the Console Redirect Switch Blade menu to return to the

management blade Console Main menu. This re-enables the blade switch console port.

Step 12 Disconnect the BX600 system serial port or the blade switch console port from the PC. See the

"Managing the Blade Switch" section on page 20 for information about configuring and

managing the blade switch.

If you need to rerun the system configuration dialog, see the "Resetting the Switch Configuration"

section on page 24.