Sharp MX-2310U Руководство по эксплуатации - Страница 21
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Принтер "все в одном Sharp MX-2310U. Sharp MX-2310U 24 страницы. Digital full color multifunctional system
Также для Sharp MX-2310U: Руководство по эксплуатации (28 страниц), Руководство по настройке программного обеспечения (46 страниц), Руководство по эксплуатации (24 страниц), Руководство по эксплуатации (19 страниц), Технический паспорт (2 страниц), Брошюра и технические характеристики (13 страниц), Руководство по эксплуатации (20 страниц)
Печатать страницу
For the users of the fax function
ABOUT THE TELEPHONE CONSUMER PROTECTION ACT OF 1991
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device, including FAX machines, to send any message unless
such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the
business or other entity, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual.
(The telephone number provided may not be a 900 number or any other number for which charges exceed local or long-distance transmission charges.)
In order to program this information into your FAX machine, you should complete the following steps:
See "Own Name and Destination Set" of Operation Guide.
Important safety instructions
• If any of your telephone equipment is not operating properly, you should immediately
remove it from your telephone line, as it may cause harm to the telephone network.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
FCC Notice to users:
This equipment complies with Part 68 of the FCC rules and the requirements adopted
by the ACTA.
On this equipment is a label that contains, among other information, a product identifier
in the format US:AAAEQ##TXXXX.
If requested, this number must be provided to the telephone company.
The REN is used to determine the number of devices that may be connected to a
telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to
an incoming call.
In most but not all areas, the sum of RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to a line, as determined
by the total RENs, contact the local telephone company.
For products approved after July 23, 2001, the REN for this product is part of the
product identifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of
0.3).
For earlier products, the REN is separately shown on the label.
If this equipment causes harm to the telephone network, your telephone company
may disconnect your service temporarily. If possible, They will notify you in advance. If
advance notice is not practical, you will be notified as soon as possible. You will also be
advised of your right to file a compliant with the FCC.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
• Do not use a telephone to report a gas leak in the vicinity of the leak.
• Do not install or use the machine near water, or when you are wet. Take care not to
spill any liquids on the machine.
• Save these instructions.
Your telephone company may make changes in its facilities, equipment, operations,
or procedures that could affect the operation of your equipment. If this happens, the
telephone company will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service. If the equipment is causing harm to the
telephone network, your telephone company may ask you to disconnect the equipment
until the problem is resolved.
If you have any questions or problems which cannot be solved by reading this manual,
please contact.
Sharp Electronics Corporation
1 Sharp Plaza,
Mahwah, NJ 07495
Telephone: 1-800-BE-SHARP
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements adopted
by the ACTA.
A compliant telephone cord and modular plug is provided with this product.
It is designed to be connected to a compatible modular jack that is also compliant. See
installation instructions for details.
21