Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector Основная информация и препараты
Просмотреть онлайн или скачать pdf Основная информация и препараты для Проектор Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector. Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector 10 страниц. Colour inkjet printer
Также для Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector: Руководство по эксплуатации (49 страниц), Руководство по эксплуатации (49 страниц), Руководство по эксплуатации (47 страниц)
Печатать страницу
Usage Guidelines
95˚F
(+35˚C)
41˚F
(+5˚C)
For SHARP Assistance (U.S.A. only)
If you encounter any problems during setup or operation of this projector, first refer to the "Troubleshooting" section on page
35. If this operation manual does not answer your question, please call toll free 1-888-GO-SHARP (1-888-467-4277) for further
assistance. Or, send us an e-mail at [email protected].
Our World Wide Web address is http://www.sharp-usa.com/.
6
Caution Concerning the Lamp Unit
Potential hazard of glass particles if lamp has ruptured. Please have
Sharp Authorized LCD Projector Dealer or Service Center replace
lamp if rupture occurs.
See "Replacing the Projection Lamp" on page 37.
BQC-PGM10X//1
Cautions Concerning the Setup of the Projector
For minimal servicing and to maintain high image quality, SHARP
recommends that this projector be installed in an area free from
humidity, dust and cigarette smoke. If the projector is used in these
environments, the lens will need to be cleaned more often, and
internal cleaning may become necessary. As long as the projector is
10 X
PG -M
regularly cleaned, use in these environments will not reduce the
overall operation life of the unit. Internal cleaning should only be
performed by a Sharp Authorized LCD Projector Dealer or Service
Center.
Notes on Operation
• The three marks shown on the left are caution labels for parts of
• The cooling fan (exhaust vent), the lamp cage cover and adjacent
• Allow at least 10 cm (3
10 X
PG -M
• If the cooling fan becomes obstructed, a protection device will
10 X
PG -M
the projector that emit intense heat during operation.
areas may be extremely hot during projector operation. To prevent
injury, do not touch these areas until they have sufficiently cooled.
15
/
inches) of space between the cooling
16
fan (exhaust vents) and the nearest wall or obstruction.
automatically turn off the projector lamp. This does not indicate a
malfunction. Remove the projector power cord from the wall outlet
and wait until the projector has sufficiently cooled. Then turn on the
power by plugging the power cord back in. This will return the
projector to the normal operating condition.