Digital Barriers EDGEVIS HD-IP450 Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары Digital Barriers EDGEVIS HD-IP450. Digital Barriers EDGEVIS HD-IP450 16 страниц.
Печатать страницуEDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE
SAFETY NOTES
The EdgeVis Encoder has been designed for use in indoor environments. It can operate in temperatures from -20˚C to
+55˚C whilst powered from 12V DC.
All deployments of an HD-IP450 encoder unit should ensure that the device is not mounted:
•
Within explosive zones
•
Within 0.5m of a powered transmitter and/or receiver antenna
•
Within the engine bay/compartment of a vehicle
•
Within 1m of a vehicle fuel fill point (direct line of sight)
WARNING: The HD-IP450 Encoder has been designed to operate from a 12V DC supply. Do not connect it directly
to mains power outlet. Use the AC/DC adapter supplied with the unit.
The following precautions must be taken to avoid damage to the unit:
•
DO NOT CONNECT DIRECTLY TO THE MAINS SUPPLY
•
Always ensure the supply is within the specified voltage range and employ
suitable filtering if voltage spikes are likely
•
Do not reverse the polarity of the DC power supply. It will cause irreparable
damage to the HD-IP450
•
Always provide a common ground between the HD-IP450 unit and all
connected equipment
WARNING: Failure to observe these precautions will invalidate the warranty.
The HD-IP450 can be deployed with or without the supplied vibration-resistant mounting plate. The base of the HD-
IP450 mounting plate is equipped with 4.2mm diameter mounting holes in six places. Additionally, 4 'Key-Hole' type
openings are provided for use with quick release fasteners. For further details on the physical dimensions of the HD-
IP450 unit and for instructions on installing the unit in a vehicle, refer to Appendix B.
ISSUED: 10 NOVEMBER 2020
PAGE 3