Actron OBD II PocketScan Code Reader CP9125 Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Испытательное оборудование Actron OBD II PocketScan Code Reader CP9125. Actron OBD II PocketScan Code Reader CP9125 10 страниц. Obdii pocketscan code reader
Печатать страницу
8 | User guide | CP9125 |
2 . Locate and plug in data link
connector (DLC) .
NOTE: The data link connector
should be located under the
dashboard on the driverside of
the vehicle . If the data link con-
nector is not located under the
dashboard as stated, a label
describing the location of the
data link connector should be
there .
3 . Observe display toggles between
"Pocket" and "Scan" .
NOTE: For a correct reading for
diagnostic trouble codes and I/M
monitor status, ignition key must
be in the ON position and engine
does not require starting . To get
a correct reading for MIL status,
engine must be started .
4 . Start engine .
5 . Press and release
NOTE: If diagnostice trouble
codes (DTCs) are already being
displayed from a previous read
operation, press and hold
for 3 seconds and release .
6 . Observe a moving * on display .
7 . View codes on display .
8 . View MIL status:
key .
9 . View I/M monitors that are
NOTE: If "No Link" message
displays, cycle ignition key to the
OFF position for 10 seconds,
then back ON and repeat "Read-
ing Diagnostic Data" procedure .
there are no codes present, the
tool will display "0 Codes" and
proceed to display MIL Status
when
is pressed .
•
To view codes, press and
release
•
If the code is a pending code,
pd will be displayed .
•
Press and release
incomplete .
•
Press and release
NOTE: If
.
.
.