Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G Дополнительное руководство - Страница 7
Просмотреть онлайн или скачать pdf Дополнительное руководство для Приемник Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G. Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G 12 страниц. Wall plate 4k receiver and room controller 100
Также для Crestron DigitalMedia 8G+ DM-RMC-4K-100-C-1G: Из руководства (2 страниц)
Печатать страницу
Rear Panel
The following illustration shows the rear panel of the DM-RMC-4K-100-C-1G.
DM-RMC-4K-100-C-1G Rear Panel
Ground (
DM IN: 8-pin RJ-45 female, shielded, with two LEDs;
DM 8G+ input, HDBaseT standard compliant;
PoDM and HDBaseT PoE PD (Powered Device) port;
Connects to the DM 8G+ output of a DM
to an HDBaseT device via CAT5e, Crestron DM-CBL-8G, or Crestron DM-CBL-ULTRA
cable;
Green LED indicates DM link status;
Solid amber LED indicates HDCP video;
Blinking amber LED indicates non-HDCP video
NOTE:
a PoDM PSE (Power Sourcing Equipment) port. Any wiring that is connected to a
PoDM PSE port is for intrabuilding use only and should not be connected to a line that
runs outside of the building in which the PSE is located.
NOTE:
pass-through of CEC is supported. If the DM IN port connects to an Ethernet-enabled
DigitalMedia™ transmitter or switcher that supports CEC over HDBaseT connectivity,
full management of CEC between the locally connected HDMI device and a control
system is supported.
24 V 0.75A: 2-pin 3.5 mm detachable terminal block;
24 Vdc power input;
Power pack included
For pin assignment information, refer to the Appendix on page 6.
Supplemental Guide – DOC. 7725A
): 6-32 screw, chassis ground lug
Receiving PODM requires connection to a switcher or other equipment that has
If the DM IN port connects directly to a DM-TX-4K-100-C-1G, simple
DM-RMC-4K-100-C-1G: Wall Plate 4K DigitalMedia 8G+ Receiver • 3
switcher, transmitter, or other DM device, or
®