Digital Data Communications LevelOne GTL-2091 Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Переключатель Digital Data Communications LevelOne GTL-2091. Digital Data Communications LevelOne GTL-2091 8 страниц. Attack prevention configuration
Также для Digital Data Communications LevelOne GTL-2091: Руководство (4 страниц)
Печатать страницуIPv6 link-local address
l
l
Global IPv6 address
To set an IPv6 link-local address in VLAN interface configuration mode, run the
following commands.
Command
ipv6 enable
ipv6 address
fe80::x link-local
Note:
l
The link-local address must begin with fe80. The default length of the prefix is 64 bit. At
manual settings only the values at the last 64 bits can be designated.
l
On a VLAN interface can only one link-local address be set.
l
After IPv6 is enabled through the configuration of the link-local address, IPv6 only takes
effect on the local link.
To set a global IPv6 address in VLAN interface configuration mode, run the
following commands.
Command
ipv6 address autoconfig
ipv6 address [ipv6-address/prefix-length |
prefix-name sub-bits/prefix-length] | [eui-64]
ipv6 address X:X:X:X::X/<0-128> anycast
Note:
l
When IPv6 is enabled through the configuration of a global address, all interconnected
IPv6 device can be handled by IPv6.
l
If a link-local address has not been set before the configuration of the global address, the
system will set a link-local address automatically.
http://www.level1.com
Purpose
Sets a link-local
address
automatically.
Sets a link-local
address
manually.
IPv6 Configuration
Purpose
Sets a global
address
automatically.
Sets a global
address.
Sets an address
of
unicast/broadca
st/multicast.
- 2 -