DIGITAL DELAY 1014-SCR Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильные аксессуары DIGITAL DELAY 1014-SCR. DIGITAL DELAY 1014-SCR 11 страниц.

Печатать страницу

12VDC Terminal:

volt source with enough amperage capable of driving both the

transbrake and the throttle stop at the same time.

Transbrake Terminal:

Transbrake solenoid. Connect the low side of the 2-Step here if

used.

Throttle Stop Terminal:

device that you want controlled by the stage times.

Ground Terminal:

on the battery or to a good steel ground, not aluminum.

Bypass Terminal:

button. This allows you to activate any device that is connected to

the Transbrake terminal without running a timing cycle. An example

of this would be vehicles that require the transbrake solenoid to be

engaged when backing up the vehicle. The bypass terminal can also

be used as an override if you flinch in single Push Button Mode at the

starting line. Simply press and hold the bypass push button and go

off your bottom bulb, avoiding the red light due to flinching.

Button-1 Terminal:

connected to Button-1 terminal is used to control the primary

delay and the secondary delay in sequence. In dual Push Button Mode

the push button connected to Button-1 terminal is used to control

the primary delay only.

Button-2 Terminal:

disabled and has no affect on the operation of the unit. In dual Push

Button Mode the push button connected to Button-2 terminal is used

to control the secondary delay only.

Bump Terminal:

button. This allows you to subtract or add a programmable amount

of time from the first delay time started every time the Bump Push

Button is depressed. One second after the transbrake releases, the

Bump Push Button will override the throttle control if pressed.

The Terminal Strip

Connect the +12VDC terminal to a switched +12

Connect the Transbrake terminal to the

Connect the Throttle Stop terminal to any

Connect the Ground terminal to the Neg. terminal

Connect the Bypass terminal to an optional push

In single Push Button Mode the push button

In single Push Button Mode this terminal is

Connect to the Bump terminal an optional push