Digital Electronics Corporation APL3700-TD Руководство по установке - Страница 11
Просмотреть онлайн или скачать pdf Руководство по установке для Промышленный компьютер Digital Electronics Corporation APL3700-TD. Digital Electronics Corporation APL3700-TD 17 страниц.
Печатать страницуPL
X
+1
383.5
PL-3700T
-0
+0.04
Series
[15.1
-0
(2) Confirm that the installation gasket is
attached to the PL unit and then place the
PL unit into the Panel from the front.
• It is strongly recommended that you use
the installation gasket, since it absorbs
vibration in addition to repelling water.
For the procedure for attaching the
installation gasket, refer to "PL3000
Series Hardware Manual".
(3) Insert each fastener's hook into the slot
and tighten it with a screwdriver. Tighten
the 8 screws gradually in an even, criss-
cross pattern.
Panel
Installation Fastener
PL
Hook
• Tightening the screws with too much
force can damage the PL unit.
• The torque required to tighten these
screws is 0.8 N•m.
Panel
Y
thickness
+1
282.5
1.6[0.06] to
-0
+0.04
10.0[0.39]
]
[11.12
]
-0
Insertion
Slots
Tighten against
the board.
Installation/uninstallation of the
front module and the control box
• To avoid an electric shock, prior to instal-
lation/uninstallation of the front module
and the control box, confirm that the PL
unit's power supply is completely turned
OFF, via a breaker, or similar unit.
1.
Uninstalling the front module and
the control box
(1) Unscrew the two attachment screws to
detach the cover for the flexible cable.
Flexible Cable
Cover
(2) Disconnect the flexible cable.
Flexible Cable
(3) Remove four screws on the installation fas-
teners for the control box.
11