Siemens SINUMERIK 808D Руководство по эксплуатации - Страница 39

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Промышленное оборудование Siemens SINUMERIK 808D. Siemens SINUMERIK 808D 48 страниц. Connecting with v60 driver
Также для Siemens SINUMERIK 808D: Руководство по эксплуатации (34 страниц), Руководство по эксплуатации (46 страниц), Инструкции (2 страниц), Руководство по установке (48 страниц)

4.2.7

Alarm 700035

Alarm description

The tool release time exceeds the monitoring time, which results in the failure of spindle tool release.

PLC information

PLC address: DB1600.DBX4.3

Subroutine: DISK_MGZ_M (SBR 60)

Remedy

● Check the interface X101 on the back of the PPU for the following:

–

Whether the input state of I1.5 is normal through the PLC status monitoring

–

Whether the connection of pin 7 is loose/broken

–

Whether pin 10 is connected to 0 V properly

● Check whether the tool release monitoring timer (T19) in the PLC is set correctly.

● Check whether the air pressure is sufficient.

● Check whether the spindle tool release switch works normally.

Note

Press the following key on the MCP to cancel the alarm after eliminating the faults.

4.2.8

Alarm description

The tool clamping time exceeds the monitoring time, which results in the failure of spindle tool clamping.

PLC information

PLC address: DB1600.DBX4.4

Subroutine: DISK_MGZ_M (SBR 60)

Remedy

● Check the interface X101 on the back of the PPU for the following:

–

Whether the input state of I1.6 is normal through the PLC status monitoring

–

Whether the connection of pin 8 is loose/broken

–

Whether pin 10 is connected to 0 V properly

● Check whether the tool clamping monitoring timer (T20) in the PLC is set correctly.

● Check whether the air pressure is sufficient.

● Check whether the spindle tool clamping switch works normally.

Service Manual

01/2017