Samsung 2220WM - SyncMaster - 22" LCD Monitor Руководство по эксплуатации - Страница 43
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Монитор Samsung 2220WM - SyncMaster - 22" LCD Monitor. Samsung 2220WM - SyncMaster - 22" LCD Monitor 49 страниц. Service manual
Также для Samsung 2220WM - SyncMaster - 22" LCD Monitor: Руководство пользователя (49 страниц), Технические характеристики (2 страниц)
Печатать страницу
12-2 IP Board Part(Power) Schematic Diagrams
Power
Switching Mode Power Supply
1.1 AC Current Input Circuit
P801 is a connector for connecting AC Power. F801 is a fuse to protect all the circuit. AC input
voltage is from 90v to 264V. R801 and R802 joined between two inputting main circuit to prevent man
from shock. L801 is used to clear up low frequency wave. C801 and C802 are used to discharge the
waves that L801 produced. High frequency waves are damped by C801 and C802. D801 is a rectifier
which composed of 4 build-in diodes, it inverts AC to DC.
1.2 High Voltage to Low Voltage Control Circuit
C804 is used to smooth the wave from rectifier. IC802 is a highly integrated PWM controller. When
rectified DC high voltage is applied to the HV pin during start-up, the MOSFET Q804 is initially off, and
the Vcc pin capacitor is charged. When the Vcc pin voltage reaches approximately 10V, the control
circuitry is activated and the soft-start begins. The soft-start circuit gradually increases the duty cycle of
the MOSFET from zero to the maximum value over approximately 4ms. If no external feedback/supply
current is fed into the FB pin by the end of the soft-start, the current Setpoint will be above the fault level,
FAULT flag is raised, if the FAULT duration exceeds 80ms, the output controller disable
Resistor R808, R809, R810, R811 are for line over voltage shutdown(OVP)
When PWM is turned off, the main current flow will be consumed through R804 and D802, This will
prevent MOSFET Q804 from being damaged under large current impulse and voltage spike.
D803 and C807 to provide internal Auxiliary voltage to Vcc pin during normal operation. Otherwise,
error amplifier and feedback current input the FB pin for duty cycle control.
1.3 DC_5V and DC_14V Output Circuit
For DC 5V, D805 is used to rectify the inducted current. R828 and C814 are used to store energy
when current is reversed. The parts including C818, C822, C820,L803 are used to smooth the current
waves.
For DC 14V, D803 is used to rectify the inducted current. R827 and C813 are used to store energy
when current is reversed. The parts including C815, C817 and L802 are used to smooth the current
waves.
3.1.4 Feedback
44