Epson 821p - PowerLite XGA LCD Projector Информация о продукте - Страница 13

Печатать страницу

Epson 821p - PowerLite XGA LCD Projector Информация о продукте

Warning:

This product includes a lamp component that contains mercury

(Hg). Please consult your state and local regulations regarding

disposal or recycling. Do not put it in the trash.

7. Gently insert the new lamp. If it doesn't fit easily, make sure

it's facing the correct way.

Caution:

Do not touch the glass portion of the lamp assembly. Touching

the glass could result in premature lamp failure.

8. Once the lamp is fully inserted, tighten its screws.

9. Lower the lamp cover into place. (The opening should be

almost covered, and the top of the lamp cover should be

flush with the surface of the projector.) Then slide the cover

closed and tighten the screw.

10.Reset the lamp timer as described in the next section.

Epson PowerLite 821p Projector

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear

the

Replace the Lamp

Note:

Do not reset the lamp timer if you have not replaced the lamp. If

you do, the

Lamp Hours

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control and select the

menu. Then press

Reset

3. Select

Lamp-Hours Reset

following:

4. Select

and press

Yes

5. Press

to return to the Reset menu or the

Esc

to exit the menu system.

9/04

message.

will not accurately reflect the number of

. You see the following:

Enter

and press Enter. You see the

Enter

Epson PowerLite 821p Projector

button