EPSON PowerLite 8300i Projector
Previewing Image Sources
You can use the Preview function to help you select the image
source.
1. Press
on the remote control.
Preview
Preview
You see the currently selected source displayed in the main
window, as shown below. All other sources (including the
currently selected source) are displayed in smaller preview
windows on the right side and at the bottom. If no
equipment is connected to a port, or if there is no incoming
signal, the preview window for that source appears blank.
Note: Movies are displayed as still images on the preview
screen.
Currently selected source
2. Press one of the
Source
switch to the desired source. Or press
preview screen without switching sources.
Note: A red highlight surrounds the preview window for the
currently selected source. You can use the
the remote control to highlight a different source, and then press
to display it.
Enter
6
EPSON PowerLite 8300i Projector
-
Preview windows
buttons on the remote control to
to exit the
ESC
pointer button on
Troubleshooting Display Problems
Follow these guidelines if you're having trouble displaying an
image.
You Can't Project an Image
If you see a blank screen or a blue screen with the
message, try the following:
Make sure the cables are connected correctly.
Make sure the power light is green and not flashing and the
lens cover is off.
If you've connected more than one computer and/or video
source, you may need to press one of the
the projector's control panel or the remote control to select
the correct source. (Allow a few seconds for the projector to
sync up after pressing the button.)
If you're using a PC laptop, press the function key on your
keyboard that lets you display on an external monitor. It
may be labeled
CRT/LCD
You may have to hold down the
Allow a few seconds for the projector to sync up after
changing the setting.
The Projector and Laptop Don't Display the
Same Image
If you're projecting from a laptop, and you don't see the same
image on the projection screen and on your computer screen,
follow these guidelines.
If you're using a PC laptop:
On most systems, there's a function key that lets you toggle
between the LCD screen and the projector, or display on
both at the same time. It may be labeled
an icon such as
key while pressing it. Allow a few seconds for the projector
to sync up after changing the setting.
If the function key doesn't permit you to display
simultaneously on both screens, you should check your
monitor settings to make sure both the LCD screen and the
external monitor port are enabled.
From the Control Panel, open the
Display Properties dialog box, click the
click
. The method for adjusting the settings
Advanced
varies by brand; you may need to click a
make sure the external Monitor port is set as your primary
display and/or enabled. See your computer's
documentation or online help for details.
5/03
No Signal
Source
or have an icon such as
key while pressing it.
Fn
CRT/LCD
. You may have to hold down the
utility. In the
Display
Settings
Monitor
buttons on
.
or with
Fn
tab, then
tab, then
Печатать страницу