Epson 9000i - PowerLite SXGA LCD Projector Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Проектор Epson 9000i - PowerLite SXGA LCD Projector. Epson 9000i - PowerLite SXGA LCD Projector 9 страниц. Epson technical brief for multimedia projectors
Также для Epson 9000i - PowerLite SXGA LCD Projector: Быстрая настройка (2 страниц), Руководство пользователя (1 страниц), Технический паспорт (2 страниц), Руководство пользователя (31 страниц), Технический обзор (7 страниц)

Epson 9000i - PowerLite SXGA LCD Projector Руководство пользователя

Projection Lamp Light

Light status
Meaning
Orange and red
Projection lamp needs replacing.
flashing alternately
Steady red
Projection lamp has burned out. Replace it to
project image.
Flashing red
Problem with projection lamp or lamp power supply.
Off
Lamp is functioning normally.

Temperature Light

Light status
Meaning
Flashing orange
Projector is too hot.
Steady red
Projector has turned off automatically because of
overheating.
Flashing red
Problem with the cooling fan or temperature sensor.
Off
Projector is functioning normally.

Using the Remote Control

The remote control uses a line-of-sight infrared signal. To use
the remote control, point it toward one of the remote control
receivers located at the front and back of the projector. You
can use the remote control up to about 32.8 feet (10 meters)
from the projector. (This distance may be shorter if the remote
control batteries are low.) You must also be within a ±30°
angle from the front or rear receiver. The remote control
buttons and commands are shown in the figure to the right.
Note: To be able to use the remote control as a wireless mouse,
make sure you've connected the mouse cable to the projector and
your computer.
The five Special Effects buttons are preprogrammed with
the following options:
1. Change the mouse cursor to a stamp
2. Draw a box
3. Use a marker pen
4. Draw a freehand line
5. Clear the screen
Note: The projector may not respond to remote control commands
in these conditions: the R/C (remote control) ON/OFF switch is
in the OFF position; batteries are weak; ambient light is too
bright; a certain type of fluorescent light is present; a strong light
source (such as direct sunlight) shines into the infrared receiver; or
other equipment emitting infrared energy is present (such as a
radiant room heater). Correct these conditions to use the remote
control or control the projector from a computer.
EPSON PowerLite 8000i/9000i Projector
Freeze
A/V mute
E-Zoom
Special effects
buttons (1-5)
Illumination
Open the cover just below the
remote control commands:
Menu
Comp1
S-Video
Auto
P in P
10/99
EPSON PowerLite 8000i/9000i Projector
IR output
Power
Freeze
Power
A/V Mute
R/C ON
R/C ON/OFF
E-Zoom
OFF
3
Enter
Enter (pointer) button
Esc button
Esc
Front
Back
button to access these
Esc
Power
Freeze
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc
Menu
Help
Help
Comp1
BNC
BNC
S-Video
Video
Video
Auto
Resize
Resize
P in P
Preset
Preset
- Volume +
Volume
- 5