Siemens EH70S501E Руководство по эксплуатации - Страница 27
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Варочная панель Siemens EH70S501E. Siemens EH70S501E 31 страница.
Печатать страницу
The powerboost function
display flashes and then
switches off
Repairs
E Ö display and numbers
F display and numbers
Visual
Fault
indication
F0
An internal error was
produced while the hob
was working.
F2
The cooking hob is too hot
and has turned off.
F4
The cooking hob is too hot
and has turned off.
F8
The cooking zone has
been working at a high
power and continuously
for too long.
The powerboost function operates the hotplate with
the most possible power. During long cooking times,
it is possible that the function will switch the hotplate
off to protect the hob from overheating. You can
continue to use the hob if the display is not flashing.
Repairs may only be carried out by trained
customer service personnel.
d
Incorrect repairs to the appliance may expose the
user to increased risks.
If E Ö and numbers appear in the display panels, there
is a fault in the electronics. Disconnect the appliance
from the mains and reconnect it. Consult the
after sales service if the display appears again.
If F and a number flash alternately in the display, your
appliance is indicating a fault. The following table
contains measures for rectifying faults.
Measure
Disconnect the cooking hob from the mains. Wait a few
seconds before connecting it again.
If the symbol continues to appear contact the technical
assistance service.
Remove the cookware from the front cooking zones. F2 it
is turned off by touching the control surface if the hob has
cooled down sufficiently.
Check whether there is any hot cookware on the control
panel. Remove the cookware from the control panel. Wait
a few minutes until the control panel has cooled a little. If
after connection F4 appears again, call the technical
assistance service.
Automatic time limitation has been activated.
To continue cooking touch any sensor.
27