Cisco Catalyst 4000 Руководство по началу работы - Страница 3

Просмотреть онлайн или скачать pdf Руководство по началу работы для IP-телефон Cisco Catalyst 4000. Cisco Catalyst 4000 31 страница. For cisco business edition 4000
Также для Cisco Catalyst 4000: Руководство (18 страниц), Подготовка к установке (11 страниц), Краткое руководство по эксплуатации (8 страниц), Руководство конечного пользователя (6 страниц), Руководство конечного пользователя (6 страниц)

License Requirements

You can license a variety of features to create an optimal Firepower System deployment for your organization. You

use the Firepower Management Center to manage licenses for itself and the devices it manages. The license types

offered by the Firepower System depend upon the type of device you want to manage:

Classic Licenses

For 7000 and 8000 Series, ASA FirePOWER, and NGIPSv devices, you must use Classic Licenses. Devices that

use Classic Licenses are sometimes referred to as Classic devices.

Cisco recommends that you use the initial setup page to add the licenses your organization has purchased; see

License Settings, page

to the Management Center as unlicensed; you must license each of them individually after the initial setup process

is over. Note that if you are setting up a reimaged appliance and you kept your license settings as part of the restore

process, this section may be prepopulated.

Smart Licenses

For Firepower Threat Defense physical and virtual devices, you must use Smart Licenses.

Cisco Smart Licensing lets you purchase and manage a pool of licenses centrally. Unlike product authorization key

(PAK) licenses, smart licenses are not tied to a specific serial number or license key. Smart licensing lets you

assess your license usage and needs at a glance.

Refer to the Firepower Management Center Configuration Guide for information about Classic Licenses and Smart

Licenses, the types of licenses for each class, and how to manage the licenses across your deployment.

When you install an appliance, make sure that you can access the appliance's console for initial setup. You can

access the console for initial setup using a keyboard and monitor with KVM, or using an Ethernet connection to

the management interface.

Note:

The management interface is preconfigured with a default IPv4 address. However, you can reconfigure the

management interface with an IPv6 address as part of the setup process.

Keyboard and Monitor/KVM

You can connect a USB keyboard and VGA monitor to the appliance, which is useful for rack-mounted appliances

connected to a keyboard, video, and mouse (KVM) switch.

Ethernet Connection to Management Interface

Configure a local computer, which must not be connected to the internet, with the following network settings:



IP address: 192.168.45.2



netmask: 255.255.255.0



default gateway: 192.168.45.1

Using an Ethernet cable, connect the network interface on the local computer to the management interface on the

appliance. Note that the management interface is preconfigured with a default IPv4 address. However, you can

reconfigure the management interface with an IPv6 address as part of the setup process.

Cisco Firepower Management Center Getting Started Guide

8. If you do not add licenses now, any devices you register during initial setup are added

License Requirements