Digital Matter Dart Руководство по началу работы - Страница 5

Просмотреть онлайн или скачать pdf Руководство по началу работы для GPS Digital Matter Dart. Digital Matter Dart 6 страниц.

Installation

Location

The housing has mounting holes for screws, bolts or cable ties. There are a few considerations for the final mounting

position of DM devices. The devices have been engineered to have the best possible GPS reception. It will work from

inside engine bays, body panels, under dashboards and other places where other GPS devices simply fail to operate

reliably. Although the units will work in these locations it is always advisable to install them where it is best able to get

signals from the GPS satellites, with the optimum position being a location with a clear 180-degree view of the sky. For

more detail, see Where/how do I mount the device?

(https://support.digitalmatter.com/en/support/solutions/articles/16000116084)

Note

The Dart, Dart2, G62 LTE & LoRaWAN and G100/G120 models all have 200mA fuses installed on the PCB for external

power inputs. Digital inputs (including ignition) and switched ground outputs do not have integrated fuses, and are not

specifically required by design, but may be installed to protect against external wiring faults.

The Fuses are self-resetting and do so when the fuse cools down. If the fault that is causing the fuse to trip is still present,

it will require the device to be removed from power sources.

This means that the installer does not have to set up their own fuses for the device.

Wiring Diagrams

See:

Dart Wiring Diagrams

Wired Device Installation Guide

Troubleshooting Steps

See here for tips for if your device isn't connecting

(https://support.digitalmatter.com/support/solutions/articles/16000087627-troubleshooting-devices-not-connecting)

(https://support.digitalmatter.com/en/support/solutions/articles/16000053494)

(https://support.digitalmatter.com/en/support/solutions/articles/16000100715)

Getting Started Guide –

Dart + Dart2

5/6