Ricoh L5130 Обучение Cip - Страница 6

Просмотреть онлайн или скачать pdf Обучение Cip для Принтер Ricoh L5130. Ricoh L5130 36 страниц.
Также для Ricoh L5130: Обучение (29 страниц), Обучение Cip (28 страниц), Обучение Cip (17 страниц), Обучение Cip (28 страниц)

Печатать страницу

CIP Training L5160/L5130

Basic Operation

Press [Execute].

Press [Cancel] to stop test feeding.

When you select [Yes] in Step 4, stop test feeding, and then rewind the media to its original

position.

Check the result of test feeding.

Press [Confirm].

Press [End].

If a problem is indicated in the result of the test feed, change the temperature settings for

each heater, and then perform test feeding again. For details about changing the heater

temperature, see "Adjusting the Heater Temperature".

• Depending on the media to be used, the media may ripple as the heater becomes hot. If the

media ripples when feeding, see "When Media Curls While Feeding".

Test Printing

Print a nozzle check pattern and check whether there are discharge defects such as nozzle

clogging (blurring or drop-out of printing).

You cannot print a test pattern on narrow media. When performing test printing, use media

that has a width of 420 mm (approx. 16.5 inches) or more.

• When using roll media, rewind the roll media and make sure there is no

warping before printing. Failure to do so may cause defects in image quality.

Performing Test Printing

• Never open the center cover or raise the lever during printing. Opening the

cover or raising the lever will abort printing.

Set media.

For details, see "Setting Media".

Change the print origin.

For details, see "Changing Print Origin".

Press the [Maintenance] key.

DWU102