Cisco 12000 - Series Chassis Modular Expansion Base Инструкции по замене Руководство - Страница 30

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сетевой маршрутизатор Cisco 12000 - Series Chassis Modular Expansion Base. Cisco 12000 - Series Chassis Modular Expansion Base 40 страниц. Internet router line card failures
Также для Cisco 12000 - Series Chassis Modular Expansion Base: Информационный лист (9 страниц), Обзорное руководство (6 страниц), Руководство по устранению неисправностей оборудования (18 страниц)

Removing and Installing Line Card Memory

Locate the route memory socket on the line card. (See

Step 4

4 and Engine 4+ line cards.)

Step 5

Remove the new SODIMM from its protective antistatic bag.

Grasp the edges of the SODIMM only. Do not touch the integrated circuit devices on the SODIMM, the

Caution

metal traces, or fingers, along the edge of the SODIMM, or the pins in the SODIMM socket.

Line up the SODIMM key with the key in the board socket. (See

Step 6

Figure 16

The SODIMM must be lined up at a 45-degree angle. (See

Step 7

When the key is in the face-up position, the metal traces on the left side of the key measure 0.9 inches

Note

(23.20 mm). The metal traces on the right side of the key measure 1.29 inches (32.80 mm). The

SODIMM can not be inserted until the keys are lined up properly.

Step 8

Place both thumbs at the end of the socket and use your index fingers to guide the module in to the socket

until it is fully seated.

Be sure your index fingers are located on the outer corners of the SODIMM to maintain even pressure

when the module is seating in the socket.

On ATM ISE line cards, take care that the module being installed in DIMM1 does not touch the

Caution

SODIMM module installed in DIMM0.

Cisco 12000 Series Router Memory Replacement Instructions

SODIMM with Key in Face-Up Position

Figure 5

for ISE line cards or

Figure

16.)

Figure

17a.)

Figure 6

for Engine

78-4338-16