Epson EMP 7800 Справочный листок быстрого запуска - Страница 5

Просмотреть онлайн или скачать pdf Справочный листок быстрого запуска для Проектор Epson EMP 7800. Epson EMP 7800 7 страниц. Projector
Также для Epson EMP 7800: Руководство по началу работы (10 страниц), Технические характеристики (4 страниц), Руководство пользователя (24 страниц), Руководство пользователя (25 страниц), Руководство пользователя (25 страниц), Брошюра и технические характеристики (4 страниц), Руководство пользователя (28 страниц), Руководство пользователя (28 страниц), Краткое справочное руководство (16 страниц)

Печатать страницу

Epson EMP 7800 Справочный листок быстрого запуска

SmartPanel Projector Driver Application Note

II. CONTROL WIRING

PROJECTOR CONTROL

RS232

5 4 3 2 1

Female DB9

9 8 7 6

RS-232 to Epson Port

Control (RS-232C)

Emitter Bud to REAR

Epson IR Window

This section specifies how RS-232 should be wired to the

Epson projector. Although this driver is RS-232-only, SP

Controls strongly recommends that you also wire IR in

case you make a decision to use Revision C of this driver,

IR/SERIAL

which uses IR control. Please Section III below for more

information.

RS-232 should be connected to the Epson control port

labeled CONTROL (RS-232C). Connection should be as

follows:

1. Wire the Panel to a female DB9 as follows:

TX to 2

RX to 3

GND to 5

1/8" Mini

2. Connect this female DB9 to the projector port labeled

Female

CONTROL (RS-232C).

The Infrared emitter (squirt) bud should be attached to the

rear IR window. IR control does not work effectively from

the front projector IR window.

Connection should be as follows:

1. Wire the Panel to a female 1/8" Mini as shown; wire

IR/SER to tip and GND to ring. Direct wiring to the IR

Emitter is not recommended as it makes removal of the

Panel for service more difficult.

2. Attach to any projector IR port using the Panel's IR

Emitter (included with the Panel).

Note that the emitter glows red when IR is emitted so wiring

can be verified.

SPECIAL CONTROL NOTE 1:

The Epson EMP-7800 projector must be configured to

STANDBY MODE: NETWORK ON in the projector

onscreen menu ADVANCED1. If the projector STANDBY

MODE is not configured to NETWORK ON, it may stop

responding to RS-232 commands.

If the projector does stop responding to RS-232 control,

manually power down the Epson projector. Once the

projector cools down, unplug the projector from the outlet

and allow it 15 seconds to reset. Reapply power and the

projector should work normally.

Note: When the projector is placed in STANDBY MODE:

NETWORK ON the projector fan remains on in standby

mode. This is normal projector behavior.

Epson EMP-7800

[email protected]