Cisco 1600 series Установка или замена руководства - Страница 7

Просмотреть онлайн или скачать pdf Установка или замена руководства для Сетевой маршрутизатор Cisco 1600 series. Cisco 1600 series 10 страниц. Rdiag router analog ipsec
Также для Cisco 1600 series: Краткое руководство по эксплуатации (12 страниц), Краткое руководство по эксплуатации (8 страниц), Руководство по установке оборудования (14 страниц)

Figure 6

Step 3

Step 4

Step 5

Step 6

Proceed with the next section, "Checking the DRAM SIMM Installation."

Checking the DRAM SIMM Installation

After installing the DRAM SIMM, you should verify the installation by reading the messages the

router displays when you power it on:

If the DRAM SIMM is installed correctly, a message similar to the following will be displayed:

Cisco Internetwork Operating System Software

IOS (tm) 1600 Software (C1600-Y-L), Version 11.1(16539)

Compiled Tue 29-Oct-96 21:30 by xxxxx

Image text-base: 0x08019CB4, data-base: 0x02005000

cisco 1600 (68360) processor (revision C) with 9728K/512K bytes of memory.

Processor board ID 01335537

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

Basic Rate ISDN software, Version 1.0.

Notice that the display shown in bold text indicates how much main memory is installed in the router.

In this example, the router has 10 MB of main memory—the memory stored in the DRAM SIMM

(8 MB) plus the memory stored in the ﬁxed memory chips (2 MB).

Replacing the Cover

Turn the router so that the rear panel is facing you, and replace the two screws that you

removed from the rear panel earlier.

Using both hands to hold the router top and bottom together, turn the router upside down

so that the top of the router is resting on the ﬂat surface. Replace the screw that you

removed earlier from the underside of the router.

Place the router right side up on the ﬂat surface and reconnect all cables to the router.

Turn ON the power by pressing the power switch to the on ( | ) position.

Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers

Checking the DRAM SIMM Installation

DO NOT INSTALL ANY WAN

MODULE WITH POWER ON