Cisco 1600 series Руководство по установке оборудования - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Сетевой маршрутизатор Cisco 1600 series. Cisco 1600 series 14 страниц. Rdiag router analog ipsec
Также для Cisco 1600 series: Краткое руководство по эксплуатации (12 страниц), Краткое руководство по эксплуатации (8 страниц), Установка или замена руководства (10 страниц)

$SSHQL[ - &RQFHUQLQJ PRGHPV IRUPHUO\ GLUHFWO\ FRQQHFWHG WR V\VWHPV

In case you ordered a new analog SRS router (Cisco 805 or Cisco 1603 Analog), and the router is

supposed to be connected to a modem which was formerly connected directly to a system/modality, it

is absolutely necessary to reset the modem to factory defaults. Otherwise the modem cannot be used

along with a SRS router.

The procedure to configure the modem via the router is called ‚reverse telnet'. In order to carry out this

procedure, please follow the steps below. This is RQO\ the procedure for 0XOWLWHFK Modems. If you

have a different type of modem, you will have to consult the instruction manual in order to reset the

modem to factory defaults.

6WHS Connect the light blue console cable to the router and to the 9 pin serial connector on the PC.

[Refer to $SSHQGL[ ( in the HW installation guide.]

6WHS Ensure that the router is connected to Ethernet.

6WHS Start Hyperterminal (click Start – Programs – Accessories – Hyperterminal – Hyperterminal).

[Refer to $SSHQGL[ in the HW installation guide.]

6WHS Enter a name for this connection and click „OK".

6WHS In the drop-down-box choose the COM port the console cable is connected to.

6WHS In the properties dialogue box click „OK".

6WHS Hit ‚Enter' until you see the router prompt, e. g. jac0356323qc828>

You have now established a connection to the router and will enter the following commands on the

router itself:

Siemens Remote Service

Installation instruction

COIT-000.812.04.02.02

Rev. 02

02-02

Seite 13/14

CO SGK

Medical Solutions

Siemens AG