Cisco 1600 series Руководство по установке оборудования - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Сетевой маршрутизатор Cisco 1600 series. Cisco 1600 series 14 страниц. Rdiag router analog ipsec
Также для Cisco 1600 series: Краткое руководство по эксплуатации (12 страниц), Краткое руководство по эксплуатации (8 страниц), Установка или замена руководства (10 страниц)

&RQQHFWLQJ &LVFR WR WKH /$1

One of the gray straight-through RJ-45-to-RJ-45 cables (contained in the package – do not use a

cable with the label „CAB-U-RJ45") is necessary for this connection. Follow these steps to connect the

router to a 10BaseT Ethernet LAN (Figure 2):

6WHS Connect one end of the Ethernet cable to the 10BASE T port.

6WHS Connect the other end of the cable to one of the ports on the 10BaseT hub, switch or network

walljack.

6WHS Check the following LEDs:

•

LNK LED (rear panel, next to 10BaseT port)---On if the router is connected

correctly to the 10BaseT Ethernet LAN.

•

LAN ACT LED (front panel)---On while there is traffic on the Ethernet LAN.

)LJXUH

1RWH If you want to connect the router directly to a PC, Server, Workstation you will need a cross

over RJ-45-to-RJ-45 cable (QRW LQFOXGHG LQ WKH SDFNDJH.

Siemens Remote Service

Installation instruction

COIT-000.812.04.02.02

Rev. 02

02-02

Seite 6/14

CO SGK

Medical Solutions

Siemens AG