Cisco 1700 series Настройка - Страница 13

Просмотреть онлайн или скачать pdf Настройка для Сетевой маршрутизатор Cisco 1700 series. Cisco 1700 series 34 страницы. Secure firewall management center
Также для Cisco 1700 series: Руководство по нормативному соответствию и безопасности (45 страниц), Руководство (15 страниц), Руководство по конфигурации (25 страниц), Примечание по применению (41 страниц), Поиск и устранение неисправностей оборудования (12 страниц), Обзорное руководство (13 страниц), Руководство (5 страниц), Краткое руководство по эксплуатации (6 страниц), Руководство по установке оборудования (46 страниц)

Печатать страницу
Cisco 1700 series Настройка
no parser cache
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname 1751-uut1
!
interface ATM0/0
mtu 4000
ip address 1.0.0.1 255.0.0.0
atm vc-per-vp 256
no atm ilmi-keepalive
pvc 0/16 ilmi
pvc 88/88
encapsulation aal5snap
!
bundle-enable
dsl operating-mode auto
bridge-group 1
!
interface FastEthernet0/0
ip address 6.0.0.1 255.0.0.0
speed auto
half-duplex
bridge-group 1
no cdp enable
!
ip classless
no ip http server
!
bridge 1 protocol ieee
!
line con 0
line aux 0
line vty 0 4
login
!
end

Using POTS Splitters and Microfilters

POTS splitters and microfilters are used on telephone lines to ensure voice- and data-call quality. This
section describes splitters and microfilters and tells how and when to use them with the Cisco 1700 series
routers. POTS splitters result in the best data and voice performance when the router and the telephone
are used on the same telephone line.
POTS Splitters
A POTS splitter (also called a splitter) is installed on a telephone line that is connected to both data
(high-frequency) and voice (low-frequency) devices. The splitter routes the high-frequency and
low-frequency signals on the telephone line to the correct device. Signals intended for the router can
disrupt voice calls; signals intended for voice calls can affect router operation.
Most splitters must be installed by the telephone company; however, some splitters can be installed by
the customer. If you are not sure what type of splitter to use, contact your service provider.
OL-3317-03
Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers
Using POTS Splitters and Microfilters
13