Cisco 1861 Series Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Сетевой маршрутизатор Cisco 1861 Series. Cisco 1861 Series 9 страниц. 1800 series
Также для Cisco 1861 Series: Информационный лист (20 страниц)
Печатать страницу
Chapter 7
Power-Up Procedures for Cisco 1800 Series Routers (Modular)
If you encounter problems when you power up the router, see
Series Routers (Modular)."
"Using the ROM Monitor"
information about the configuration register, see
section of
To view the boot sequence through a terminal session, you must have a console connection to the Cisco
Note
router before the router powers up.
To power up the router, perform the following steps:
Step 1
Make sure that your PC is powered up and connected as described in the
section on page
Move the power switch to the ON position.
Step 2
The following indications appear:
•
The green SYS PWR LED on the front of the chassis comes on.
•
The fan operates.
The LEDs on the chassis come on (although not necessarily at the same time), and some LEDs may go
off again. The actual LED activity depends on your installation.
If you encounter problems when you power up the router, see
Routers (Modular)"
Startup messages appear in your terminal emulation program window.
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
Caution
interpreted as the first command typed when the messages stop, which might cause the router to power
off and start over. It takes a few minutes for the messages to stop.
The startup messages vary, depending on the software installed on your router.
If the startup messages end with the following lines, you know that the Cisco Router and Security
•
Device Manager (SDM) software is installed on the router.
yourname con0 is now available
Press RETURN to get started!
For instructions on configuring your router by using SDM, see
Manager (SDM) Quick Start
Note
If the startup messages end with the following lines, the router is ready for initial configuration using
•
the setup facility (system configuration dialog) or the command-line interface (CLI). Enter yes to
continue with the setup facility; enter no to continue with the CLI.
OL-5876-03
For information about the ROM monitor and the bootstrap program, see the
section of the
Cisco 1800 Series Router Software
7-2.
Guide.
Because SDM is installed on your router by default, we recommend using SDM to perform the
initial configuration.
Chapter 8, "Troubleshooting Cisco 1800
Cisco 1800 Series Router Software
the"Changing the Configuration Register Settings"
Configuration.
"Troubleshooting Cisco 1800 Series
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
Powering Up Cisco 1800 Series Routers
Configuration. For
"Checklist for Power Up"
Cisco Router and Security Device
7-3