Cisco 1905 Установка и модернизация - Страница 8

Просмотреть онлайн или скачать pdf Установка и модернизация для Сетевой маршрутизатор Cisco 1905. Cisco 1905 24 страницы. 1900 series

Modules Internal to the Cisco 1941 Router
Do not, under any circumstances, tamper with or attempt to remove the safety shields protecting the
Caution
WIC/HWIC slots and connectors.

Installing and Removing DRAM UDIMMs

Before you remove or install a DRAM UDIMM, remove the chassis cover as described in the
and Closing the Chassis" section on page
Caution
When you remove or install UDIMMs, always wear an ESD-preventive wrist strap, and ensure that it
makes good contact with your skin. Connect the equipment end of the wrist strap to the metal part of the
chassis.
Handle DRAM UDIMMs by the edges only. UDIMMs are ESD-sensitive components and can be
Caution
damaged by mishandling.
DRAM UDIMM Location and Orientation
On Cisco 1900 series routers, a single DRAM UDIMM socket is located on the system board. See
Figure 3
DRAM UDIMMs have a polarization notch on the mating edge to prevent incorrect insertion.
shows the polarization notch on a DRAM UDIMM.
Figure 4
Removing a DRAM UDIMM
To remove a DRAM UDIMM from the system board, follow these steps:
Remove the cover to access the system board. If necessary see the
Step 1
section on page
Locate the DRAM UDIMM on the system board. See the
Step 2
location of the UDIMM sockets.
Step 3
Pull the latches away from the DRAM UDIMM at both ends; this lifts the UDIMM slightly. Then pull
the UDIMM out of the socket. (See
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
8
for the location of the UDIMM connector.
DRAM UDIMM Showing Polarization Notch
5.
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
5.
1
"Locating Modules" section on page 7
Figure
5.)
"Opening and Closing the Chassis"
"Opening
Figure 4
for the