Cisco 2500 Series Руководство по конфигурации - Страница 17

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Сетевой маршрутизатор Cisco 2500 Series. Cisco 2500 Series 19 страниц. Wireless controller
Также для Cisco 2500 Series: Руководство по установке (12 страниц), Руководство по развертыванию (23 страниц), Руководство по конфигурации (50 страниц), Руководство по началу работы (47 страниц)

Step 2

The access server is now configured properly and is ready to use. Enter the command setup

if you want to modify the parameters after the initial configuration. To perform more

complex configurations, enter the command configure. For information on configuration,

see the publication Access and Communications Servers Configuration Guide.

Checking Your Settings

You can check the value of the settings you have entered by entering at the # prompt the

command show running-config if you are running Cisco IOS Release 11.0 or later, or the

command write terminal if you are running a Cisco IOS Release earlier than 11.0:

router# show running-config

configuration register is 0x2102

Configuring interface Async6:

Default client IP address for this interface [172.16.72.16]:

Configuring interface Async7:

Default client IP address for this interface [172.16.72.17]:

Configuring interface Async8:

Default client IP address for this interface [172.16.72.18]:

The configuration you have entered is now displayed and you are asked if you

want to use the displayed configuration. If you answer no, you can begin the

configuration again. If you answer yes, the configuration will be entered and saved

in the startup configuration:

Use this configuration? [yes/no]:yes

Press RETURN to get started!

[OK]

Use the enabled mode 'configure' command to modify this

configuration.

Configuring the Cisco 2500 Series Access Server 4-17

Configuring the Access Server