Cisco 2524 - Router - EN Руководство по конфигурации - Страница 14

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Сетевой маршрутизатор Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 страницы. Troubleshooting guide
Также для Cisco 2524 - Router - EN: Руководство по конфигурации (23 страниц), Обзор (10 страниц), Подготовка к установке (19 страниц), Руководство по устранению неполадок (4 страниц)

Configuring the Router

Configuring ISDN

If you have an ISDN BRI WAN module, configure the BRI port for ISDN. This section

explains typical ISDN configurations for one or two B channels. In the examples that

follow, the BRI port is configured for IP routing, Challenge Handshake Authentication

Protocol (CHAP), and Point-to-Point Protocol (PPP) encapsulation.

Take the following steps to configure the router for a basic ISDN PPP connection on a

single B channel or two B channels, substituting the correct addresses and host names as

appropriate for your network:

Step 1

Step 2

Note

the router to which the ISDN connection will be made. The username and password are

case sensitive.

Step 3

4-14 Cisco 2524 and Cisco 2525 Router User Guide

Enter enable mode:

Router> enable

password: enablepassword

Enter the configure terminal command. Then enter the host name and password

that the router will use for CHAP caller identification:

Router# config term

Router (config)# username targetrouter password abc

The username and password must match the username and password already set on

If you have not already done so, enter the isdn switch-type command to configure

the ISDN switch type:

router (config)# isdn switch-type switch-type

Refer to Table 4-1 earlier in this chapter for a list of ISDN switch types.