Cisco 2600XM Series Краткое руководство по эксплуатации - Страница 18

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 2600XM Series. Cisco 2600XM Series 29 страниц. Including license and warranty
Также для Cisco 2600XM Series: Информационный лист (6 страниц), Информационный лист (11 страниц), Краткое руководство по эксплуатации (29 страниц)

Power Up the Router

You are ready to power up the Cisco router after you have completed the following steps:

• Chassis is securely mounted and grounded.

• Power and interface cables are connected.

• Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, and no parity.

• You have selected passwords for access control.

• You have determined the IP addresses for the Ethernet and serial interfaces.

The following indicator LEDs provide power, activity, and status information:

• POWER (green)—Lit when power is on

• RPS (green)

Off—No redundant power supply (RPS) is present

–

Blinking—System is booted, RPS is present, RPS failure

–

Continuous on—System is booted, RPS is present, no RPS failure

–

• ACTIVITY (green)

–

Slow, steady blinking—System is booting

–

Blinks during system activity, such as interrupts and packet transfers

To power up your Cisco router and verify that it goes through its initialization and self-test, perform this procedure. When the

procedure is finished, the Cisco router is ready to configure.

To view the boot sequence through a terminal session, you must have a console connection to the Cisco router before

Note

it powers on.

Step 1

Make sure that your PC is powered up and connected as described in the "Checklist for Power-Up" section.

Step 2

Move the power switch to the ON position.

The green POWER or PWR LED on the front of the chassis comes on and the fan operates. If this does not happen, see

the power-up procedure in the Cisco 2600 Series Routers Hardware Installation Guide.

Messages begin to appear in your terminal emulation program window.

Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted

Caution

as the first command typed when the messages stop, which might cause the router to power off and start over. It

takes a few minutes for the messages to stop.