Command
ip address dhcp-alloc
rip authentication-mode
rip input
rip metricin
rip metricout
rip output
rip split-horizon
rip version
rip work
shutdown
udp-helper server
Table 15
Ethernet Port View
[4500]interface ethernet 1/0/1
Command
am ip-pool
arp static
broadcast-suppression
description
dot1x max-user
dot1x port-control
dot1x port-method
dot1x supp-proxy-check
duplex
enable snmp trap
flow-control
lacp enable
lacp port-priority
line-rate
loopback
loopback-detection
control enable
loopback-detection enable
loopback-detection per-
vlan enable
mac-address blackhole
mac-address dynamic
mac-address max-mac-count
mac-address static
mac-authentication
Description
Configure a VLAN interface to obtain IP address using DHCP
Configure RIP-2 authentication mode and its parameters
Allow an interface to receive RIP packets
Configure the additional route metric added to the route
when an interface receives RIP packets
Configure the additional route metric to the route when an
interface transmits RIP packets
Allow an interface to transmit RIP packets to the network
Configure an interface to use split horizon when transmitting
RIP packets
Configure the RIP version of RIP packets on an interface
Enable the running of RIP on an interface
Disable the VLAN interface
Configure the relay destination server
Description
Configure the IP address pool for access management on a
port
Configure the static ARP mapping entries in an ARP mapping
table
Configure the broadcast traffic size enabled on port
Configure name for a port
Specify maximal on-line user number per port
Specify port authenticated status
Specify port controlled method
Check whether user(s) access the networks by proxy or not
Configure the duplex mode of the port
Enable/disable current port to transmit the LINK UP and LINK
DOWN trap information
Enable flow control on the Ethernet port
Enable LACP
Configure port priority value
Limit the total rate of the packets delivered by interfaces
Configure the Ethernet port to perform the loopback test
Enable loopback detection control function on a trunk or
hybrid port
Enable port loopback detection
Configure loopback detection on all VLANs on trunk and
hybrid ports
Backhole entry, no age, can be added or deleted, and is saved
to the configuration file
Dynamic entry, age, can be added or deleted, and is lost after
reset
Limit the number of MAC addresses to be learned by an
Ethernet port
Static entry, no age can be added or deleted, and is saved to
the configuration file
Enable the centralized MAC address authentication feature on
a specified port or globally
15
Web Command
Administration -> IP Setup
-> Device -> VLAN Interface
Device -> VLAN Interface
Web Command
Port -> Administration
Port -> Administration
Port -> Administration
Port -> LACP
Port -> LACP
Tools -> Loopback
Port -> Administration
Печатать страницу