Cisco 3620 Краткое руководство по эксплуатации - Страница 27
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 3620. Cisco 3620 37 страниц. Rack-mount and wall-mount
Также для Cisco 3620: Руководство пользователя (17 страниц), Примечание по конфигурации (18 страниц)
Печатать страницу
Figure 22
IP Addresses in the Renumbered Subnet for SDM
Crossover cable
Example static
or dynamic IP address:
172.16.30.2/255.255.255.0
Step 9
Open a web browser on the PC, and enter the SDM URL, using the new IP address that you gave the LAN interface:
https://new-IP-address/flash/sdm.shtml
In the Figure 22 example, you would enter:
https://172.16.30.1/flash/sdm.shtml.
Step 10 Enter the username and password that you specified in Step 6 above.
Step 11 When the SDM System Overview window appears, you can use the wizard buttons on the left side of the window to
configure other features. Buttons are provided for LAN, WAN, firewall, and VPN configurations.
For more information about SDM, refer to the Cisco Router and Security Device Manager Troubleshooting Guide at the
following URL:
http://www.cisco.com/go/sdm
See the "Obtaining Documentation" section on page 32 for information about accessing this document.
Initial Configuration Using the Setup Command Facility
This section shows how to use the setup command facility to configure a host name for the router, set passwords, and configure
an interface for communication with the management network. If you see the following messages at the end of the startup
sequence, the setup command facility has been invoked automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
The setup command facility prompts you for basic information about your router and network, and it creates an initial
configuration file.The prompts vary, depending on your router model, the installed interface modules, and the software image.
The following example and the user entries (in
For a description of the interface numbering, see the "Interface Numbering" section on page 31.
Note
If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.
Press Ctrl-C, and enter setup at the enable mode prompt (
172.16.30.0 subnet
Example configured IP address:
172.16.30.1/255.255.255.0
) are shown as examples only.
bold
).
3600#
27