Cisco 3845 - Security Bundle Router Краткое руководство по эксплуатации - Страница 33

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 3845 - Security Bundle Router. Cisco 3845 - Security Bundle Router 38 страниц. Integrated services routers
Также для Cisco 3845 - Security Bundle Router: Политика безопасности, не связанная с собственностью (30 страниц), Руководство по устранению неполадок (15 страниц), Краткое руководство по эксплуатации (40 страниц)

no ip routing

interface GigabitEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface GigabitEthernet0/1

shutdown

no ip address

end

Step 10 Respond to the following prompts. Choose [2] to save the initial configuration:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

The user prompt appears:

Router>

Step 11 Verify the initial configuration. See the "Verify the Initial Configuration" section on page 34 for verification

procedures.

Initial Configuration Using the Cisco CLI—Manual Configuration

This section shows how to display a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration. You can use the CLI if the following messages appear at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM

to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager (SDM)" section on

page 30.

For help with interface and port numbering, see the "Port Numbering" section on page 29.

To proceed with manual configuration using the CLI, enter no when the power-up messages end:

Step 1

Would you like to enter the initial configuration dialog? [yes/no]: no

Press Return to terminate autoinstall and continue with manual configuration:

Step 2

Would you like to terminate autoinstall? [yes] Return