Cisco Nexus 7000 Series Ссылка - Страница 15

Cisco Nexus 7000 Series NX-OS High Availability Commands

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m

out-of-service

To power off a supervisor module in the Cisco NX-OS software, use the out-of-service command.

Syntax Description

module

module-number

Defaults

None

Command Modes

Global configuration mode

Supported User Roles

network-admin

vdc-admin

Release

Command History

4.0(1)

Usage Guidelines

This command is not supported on line card modules. For line card modules, use the poweroff command.

You can use the out-of-service command only in the default virtual device context (VDC).

Use this command to safely remove a module from service in the software. Before bringing a module

back into service, you must remove the physical hardware module from the chassis and reinsert it.

This command does not require a license.

Examples

This example shows how to take a supervisor module out of service:

switch# configure terminal

switch(config)# out-of-service module 3

Related Commands

Command

poweroff

reload module

OL-23374-01

out-of-service module module-number

Specifies an I/O module.

Module number. The range is from 1 to 18.

Modification

This command was introduced.

Description

Shuts down a supervisor of a line card module in the Cisco NX-OS

Reloads a module in a device.

Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x

out-of-service

HACR-5