Cisco Nexus 9000 Series Руководство по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке для Сетевой маршрутизатор Cisco Nexus 9000 Series. Cisco Nexus 9000 Series 12 страниц. Switch chassis
Также для Cisco Nexus 9000 Series: Руководство по быстрому запуску конфигурации (6 страниц), Руководство по конфигурации (32 страниц), Руководство по конфигурации (32 страниц), Руководство (30 страниц), Установка (8 страниц), Краткое руководство по эксплуатации (14 страниц), Руководство (16 страниц)

Grounding the Chassis

• Wire-stripping tool to remove the insulation from the grounding wire.

Step 1

Use a wire-stripping tool to remove approximately 0.75 inch (19 mm) of the covering from the end of the grounding

wire.

Step 2

Insert the stripped end of the grounding wire into the open end of the grounding lug, and use a crimping tool to crimp

the lug to the wire (see Callout 2 in the following figure). Verify that the ground wire is securely attached to the grounding

lug by attempting to pull the wire out of the crimped lug.

Figure 5: Grounding the Chassis

Chassis grounding pad

Grounding cable, with 0.75 in. (19 mm) of insulation

stripped from one end, inserted into the grounding lug

and crimped in place

Step 3

Secure the grounding lug to the chassis grounding pad with two M4 screws (see Callouts 1 and 3 in the previous figure),

and tighten the screws to 12 in-lb (1.36 N·m) of torque.

Step 4

Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site to ensure an

adequate earth ground for the switch. If the rack is fully bonded and grounded, connect the grounding wire as explained

in the documentation provided by the vendor for the rack.

Cisco Nexus 9372TX ACI-Mode Switch Hardware Installation Guide

Two M4 screws used to secure the grounding lug to

the chassis

Installing the Switch Chassis