Cisco uBR924 Установка и ввод в эксплуатацию - Страница 25
Просмотреть онлайн или скачать pdf Установка и ввод в эксплуатацию для Сетевой маршрутизатор Cisco uBR924. Cisco uBR924 34 страницы. Cable access router
Печатать страницуReconfigure the Router (continued)
!
dial-peer voice 2 pots
destination-pattern 2000
port 0
!
dial-peer voice 10 voip
destination-pattern 1000
session target ras
!
dial-peer voice 20 voip
destination-pattern 2000
session target ras
!
interface Ethernet0
ip address 10.1.0.25 255.255.0.0
no ip directed-broadcast
no ip route-cache
bridge-group 59
bridge-group 59 spanning-disabled
!
interface cable-modem0
ip address 10.1.0.25 255.255.0.0
no ip directed-broadcast
no ip route-cache
cable-modem downstream saved channel 477000000 56
bridge-group 59
bridge-group 59 spanning-disabled
!
ip classless
no ip http server
!
!
line con 0
transport input none
line vty 0 4
!
end
Note: The example above shows VoIP setup in bridging mode when using Cisco Network Registrar (CNR)
version 2.5 and higher. CNR assigns E.164 addresses to local voice ports and uses the DHCP Option to define
E.164 addresses-to-port assignments. The Cisco uBR924 cable access router software creates the dial-peers,
starts H.323 RAS gateway support, and registers the E.164 addresses with the gatekeeper. The gatekeeper
resolves the remote peers' IP addresses. Support for RAS and H.323v2 in Cisco gatekeeper products are found
in Cisco IOS Release 12.0(5)T or higher. Support for multiple classes of service when using Cisco uBR7200
CMTS equipment is found in any Cisco 12.0(4)XI or higher headend image.
If you are not using CNR or Cisco gateway products running Cisco IOS Release 12.0(5)T software, you can set
static routes. For the local peers, define the port and E.164 addresses. For remote peers, define the remote peers'
IP addresses and E.164 addresses. The local dial peers assign an E.164 address to the POTS port.
23