Cisco WS-X3011 Примечание по конфигурации - Страница 12
Просмотреть онлайн или скачать pdf Примечание по конфигурации для Сетевой маршрутизатор Cisco WS-X3011. Cisco WS-X3011 46 страниц.
Печатать страницу
Installing the Router Card
Data bits
Stop bits
Handshaking
Terminal emulation
Duplex
Soft flow control
(XON/XOFF)
Hard flow control
(RTS/CTS)
Autobaud upon break
Line wrap
Screen scroll
CR translation
Backspace (BS)
translation
Break length
(milliseconds)
Enquiry (ENQ)
EGA/VGA true
underline
Terminal width
ANSI 7 or 8 bit
commands
Microsoft Windows™,
terminal emulation
Step 4
Step 5
Step 6
12 Router Card (WS-X3011) Configuration Note
8
1
None
VT100
Full
Off (input and output)
Off
On
On
On
CR
Destructive
350
Off
Off
890
7
Disable the "Use Function, Arrow, and Ctrl Keys for
Windows" option, located in the Terminal Preference menu
Power on the switch.
At power on (cold boot), the switch performs a series of self-test diagnostics that verify
that hardware components are functioning. The diagnostic self-test for the switch
displays two different screens (lists of information), depending on whether you perform
a cold boot (power on cycle with full diagnostics), or a warm boot (a reset without full
diagnostics). For detailed information about these diagnostics, refer to the Catalyst 3X00
Installation and Configuration Guide.
At the end of the boot messages, you should be prompted to press RETURN. The
Greeting screen of the switch Console Manager should appear, as shown in Figure 8.
If the diagnostic list does not appear, or the list is garbled, refer to the "Encountering
Communication Problems" section in this document..
At the Greeting screen, press RETURN to enter the Main menu. The contents of the Main
menu, instructions for setting a Password and all information within the menus and
sub-menus are described in the Catalyst 3X00 Installation and Configuration Guide.
Access the router card command-line interface by pressing Ctrl-R from the switch Main
menu.