Cabane Classic Adirondack Инструкции по сборке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по сборке для Внутренняя отделка Cabane Classic Adirondack. Cabane Classic Adirondack 2 страницы.

Install (1) short connector bolt through pre-drilled hole

through arm and through upper back yoke (Right Picture).

Finger tighten flat & lock washers and nuts. Do not tighten at

this time. Repeat process for opposite side.

Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause

damage to the item.

Step Two: Arm Assembly

Arms should be installed with curve side on the in-

side of the chair. (Left Picture). Place Arm on top

of Front Leg. Align pre-drilled hole in arm with the

pre-drilled hole located at the top of the Front

Leg. Install a short connector bolt through pre-

drilled hole in the Front Leg, then through pre-

drilled hole under arm. Install flat washer, lock

washer and nuts. Do not tighten at this time.

Repeat process on other side.

Step Three: Arm & Back Attachment

Step Four: Back Assembly

Place Back Assembly on top of mounting surface of Rear

Legs, (Left Picture). Push Back Assembly forward until it's

aligned with Seat Assembly. Hold Back Assembly in place and

install (4) Robertson Head Screws into the base on each side.

There are no predrilled holes, you need to align the

horizontal bar with the sides of the base, making sure that

the base of the backrest aligns with the seating surface.

Step Five: Tightening of Hardware