Cisco 1700 series Руководство по конфигурации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Беспроводная точка доступа Cisco 1700 series. Cisco 1700 series 25 страниц. Secure firewall management center
Также для Cisco 1700 series: Руководство по нормативному соответствию и безопасности (45 страниц), Руководство (15 страниц), Примечание по применению (41 страниц), Поиск и устранение неисправностей оборудования (12 страниц), Обзорное руководство (13 страниц), Настройка (34 страниц), Руководство (5 страниц), Краткое руководство по эксплуатации (6 страниц), Руководство по установке оборудования (46 страниц)

Печатать страницу
Cisco 1700 series Руководство по конфигурации
Cisco WIC-1ENET Requirements
•
•
•
•
•
•
Cisco WIC-1ENET Requirements
This section describes the requirements and supported standards for the Cisco WIC-1ENET card.
Note
Cisco WIC-1ENET cards marked with the text "INSTALL IN slot 0 ONLY" can be used in any WIC slot
if your router is running Cisco IOS Release 12.2(2)XJ or higher.

Processor Requirements

The MPC 860 microprocessor (revision B5 or later) is required for using the Cisco WIC-1ENET card.
This processor has been applied to all Cisco 1700 series routers shipped after November 21, 1999.
Cisco 1700 series router serial numbers starting with JAB0347XXXX, JEU0347XXXX, or
JMX0347XXXX and after have been manufactured with the Model MPC 860 revision B5 or later
microprocessor.
The serial number incorporates a manufacturing date code. The format is LLLYYWWSSSS, in which:
LLL—Location at which the unit was built.
YY—Year that the unit was built (1997=01, 1998=02, 1999=03, 2000=04, 2001=05).
WW—Workweek of the year that the unit was built.
SSSS—Serial number.
The processor version information is displayed at boot up. You can also verify the processor revision by
entering the show version command at the IOS command-line interface Router# prompt.

Memory Requirements

To run IOS images that support the Cisco WIC-1ENET card, the router must have a minimum amount
of Flash memory and dynamic RAM (DRAM). For details on the memory requirements for each image,
see Release Notes for the Cisco 1700 Series Routers for Cisco IOS Release 12.2(4)T.

Software Requirements

The Cisco WIC-1ENET card requires Cisco IOS Release 12.2(2)XJ or later if the card is installed in any
WIC slot other than slot 0 or if more than one card is installed.
The card can be used with Cisco IOS Release 12.2(4)T, but the card must be installed in slot 0 and only
one Cisco WIC-1ENET card can be installed in the router.
Cisco WIC-1ENET Requirements
2
Connecting a Cisco WIC-1ENET Card to the LAN
Obtaining Documentation
Documentation Feedback
Cisco Product Security Overview
Obtaining Technical Assistance
Obtaining Additional Publications and Information
78-11422-03