Cisco 1700 series Обзорное руководство - Страница 11

Просмотреть онлайн или скачать pdf Обзорное руководство для Беспроводная точка доступа Cisco 1700 series. Cisco 1700 series 13 страниц. Secure firewall management center
Также для Cisco 1700 series: Руководство по нормативному соответствию и безопасности (45 страниц), Руководство (15 страниц), Руководство по конфигурации (25 страниц), Примечание по применению (41 страниц), Поиск и устранение неисправностей оборудования (12 страниц), Настройка (34 страниц), Руководство (5 страниц), Краткое руководство по эксплуатации (6 страниц), Руководство по установке оборудования (46 страниц)

Печатать страницу
Cisco 1700 series Обзорное руководство

Additional Required Equipment

Depending on your local network and which Cisco WAN interface cards you install in your
router, you will require other items, listed in Table 1-5, to complete your router installation.
Table 1-5
Equipment
Ethernet hub
Ethernet switch
Phillips screwdriver
Cisco WAN interface card
Straight-through
RJ-45-to-RJ-45 cable
Serial cable
NT1
Asynchronous modem
Additional Required Equipment
When You Use It
A hub connects pieces of network equipment (including the
Cisco 1700 router) to create a network. You can use a 10-, 100-,
or 10/100-Mbps hub with the Cisco 1700 router.
A switch connects pieces of network equipment (including the
Cisco 1700 router) to create a network. You can use a 10-, 100-,
or 10/100-Mbps switch with the Cisco 1700 router.
Although the WAN interface cards use thumbscrews, you might
need a Phillips screwdriver to loosen the WAN interface card
slot cover.
In order to make a WAN connection, the Cisco 1700 router must
have a supported WAN interface card installed. The router
supports up to two cards. You can order the cards when ordering
the router, and they will be installed for you. You can order the
cards separately, after receiving the router, and install them
yourself.
This cable connects the router to the Ethernet LAN and the
WAN interface cards to various WAN services, including ISDN,
T1/FT1, and 56-kbps services. You will need one cable for each
connection that requires this cable type.
This cable connects a serial card to serial services. You must
order this cable from Cisco. For detailed information about
serial cable types, refer to the Cisco WAN Interface Cards
Hardware Installation Guide that comes with every card.
Some ISDN service providers require a Network Termination 1
device to connect an ISDN S/T port to the ISDN line.
Connect a modem to the AUX port on the router when you want
to configure the router from a remote location.
Additional Required Equipment
Cisco 1700 Router Overview 1-11