ACU-RITE 00439DI Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Погодная станция ACU-RITE 00439DI. ACU-RITE 00439DI 20 страниц.

3-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT

off the ground, in an open area. Higher is better for wind measurements - the

National Weather Service recommends 33 feet high!

MOUNTING OPTIONS

onto wooden posts or surfaces that are 2"x4" or larger. The sensor can also be

mounted directly to 3/4" steel or

PVC pipe (available at hardware

stores and home centers).

LEVEL INSTALLATION

bubble level (not included) to ensure

level installation for accurate wind

measurement.

Top or Side Mount

1. Insert the mounting base into the

hole on the bottom of the sensor.

2. Use one of the screws included

in the hardware bag to fasten

the lower sensor housing to the

mounting base.

3. Fasten mounting base to a post

or railing using 2 screws.

Pipe Mount

1. Insert pipe or similar item all the way

into the hole on the bottom of the sensor.

Note: Mounting base is not used.

2. Use one of the screws included in the

hardware bag to fasten the lower sensor housing securely to the pipe.

The 3-in-1 sensor is now ready to use.

Basic Setup is Complete

The 3-in-1 sensor will now synchronize with the display unit. It may take a few

minutes for synchronization to complete. If both or one of the units appear to be

functioning improperly, please refer to the troubleshooting section.

Mount the sensor at a minimum height of 5 feet (1.5 meters)

The included mounting bracket is designed to screw directly

Use a

Top Mount

Side Mount

Pipe Mount

Do not install during

electrical storms.

Do not place pipe

or sensor near

electrical lines or

electrical equipment.