DigitaLinx DL-AS31-1H1DP1V Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель DigitaLinx DL-AS31-1H1DP1V. DigitaLinx DL-AS31-1H1DP1V 13 страниц.
Печатать страницу
1. Verify all components included with the switcher are present before
installation.
2. If the switcher will be permanently mounted to a surface, attach
the included mounting brackets with the supplied screws.
3. If the switcher will be sitting on a shelf, attach the included rubber
feet to the bottom of the unit.
4. Turn off power and disconnect the audio/video equipment by
following the manufacturer's instructions.
5. If the switcher needs to use a preset EDID instead of the EDID of
the connected display, send the appropriate RS232 EDID command
to the DL-AS31.
6. Connect HDMI signal cables between the HDMI sources and the
HDMI Input port.
7. Connect a DisplayPort signal cable between the DisplayPort source
and the DisplayPort Input port.
8. Connect an audio signal cable between the audio source and the
Audio Input port for DisplayPort devices that do not support
embedded audio.
9. Connect a VGA signal cable between the VGA source and the VGA
Input port.
10. Connect an audio signal cable between the audio source and the
Audio Input port.
11. Connect an HDMI cable between the display and the HDMI Output
port.
12. Connect an analog audio cable between an audio amplifier and the
Audio Output port.
13. Connect an RS232 cable between the control system and the RS232
port. The distance between PC and the switcher should be within
100m.
14. If the switcher will be controlled via contact closure, connect the
controller to the CONTACT and DISPLAY ports.
15. Connect the included power supply to the switcher.
16. Power on attached audio/video devices.