Cabela's Adventure 5500 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Металлоискатель Cabela's Adventure 5500. Cabela's Adventure 5500 10 страниц. Professional metal detector
Также для Cabela's Adventure 5500: Руководство пользователя (20 страниц), Руководство пользователя (20 страниц)
Печатать страницу
Batteries
Use ALKALINE batteries only.
To install the batteries:
G
1
Remove the battery cover by
disengaging the clip at the back.
G
2
Align the polarity of the batteries
correctly, with the positive "+"
toward the coil plug connection,
as indicated by the + and –
indicators on the housing.
G
Insert (2) 9-Volt ALKALINE
3
batteries, with the contacts
pointed inward, and press down
on the back of the batteries to
snap them into place.
Some brands of batteries will require moderate force to clear the retaining tabs.
G
4
Replace the battery door.
G
3-Segment Battery Indicators.
5
Segments Illuminated
Battery Voltage
All three segments
More than 8.5 volts
Two segments
7.6 to 8.5 volts
One segment
7.0 to 7.5 volts
No segments
Less than 7.0 volts
The detector will stop working soon after all segments have disappeared (approximately 6.6 volts).
Most metal detector problems are due to improperly installed batteries, or the use of non-alkaline or
discharged batteries. If the detector does not turn on, please check the
batteries.
DO NOT MIX OLD AND NEW BATTERIES
6
In The Field Techniques
PINPOINTING
Accurate pinpointing takes practice and is best
accomplished by "X-ing" the target area.
1. Once a buried target is indicated by a good
tone response, continue sweeping the coil
over the target in a narrowing side-to-side
pattern.
2. Take visual note of the place on the ground
where the "beep" sounds.
3. Stop the coil directly over this spot on the
ground.
4. Now move the coil straight forward and
straight back towards you a couple of times.
5. Again make visual note of the spot on the
ground at which the "beep" sounds.
6. If needed, "X" the target at different angles
to "zero in" on the exact spot on the ground
at which the "beep" sounds.
When pinpointing a target, try drawing an "X",
as illustrated, over where the tone is induced.
COIL MOVEMENT
When swinging the coil, be careful to keep it
level with the ground about 2.5cm (1 inch)
from the surface. Never swing the coil like a
pendulum.
WRONG
CORRECT
15