Message/Light
NO BORDERLESS WITH THIS
SIZE
RELOAD PAPER
Note:
These messages alternate.
NO INK CRTG
NO MNT TNK
NOT STRAIGHT RELOAD
NOZZLES STILL CLOGGED
PAPER NOT CUT
PAPER NOT STRAIGHT
PAPER OUT
PLEASE USE GENUINE EPSON
INK CARTRIDGES
REAR COVER OPEN
RELEASE LEVER
REMOVE PAPER JAM
RELOAD PAPER
RELOAD PAPER
INSERT DEEPLY
REMOVE PAPER
REPLACE CNVRSION CRTG
REPLACE INK CRTG
SERVICE REQ.
SET INK CRTG
Light
Explanation
—
Borderless setting is selected for
A2-size sheets (11.7 × 16.5)
B
Ink light on
Ink cartridge(s) not installed or ink
lever raised.
—
The maintenance tank is not installed.
Paper light on
Cut sheet paper is not loaded straight.
—
Head cleaning did not clear the
nozzles.
Paper light
Roll paper was not cut correctly. The
flashing
cutter may be blunt or incorrectly
installed.
Paper light
The paper slipped and fed into the
flashing
printer at an angle or is loaded
incorrectly.
Paper light on
No paper is loaded or the paper ran
out, or it is loaded incorrectly.
—
A non-genuine Epson ink cartridge is
installed.
—
The rear cover is open.
Paper light
Paper has jammed in the printer.
flashing
Paper light on
Printer cannot detect paper or the
PAPER NOT CUT error was cleared.
Paper light on
Manually loaded sheet is not inserted
far enough.
Paper light on
Paper is too thick for head cleaning.
Printer could not feed the paper.
—
The conversion cartridge needs to be
replaced.
B
Ink light on
Ink cartridge is expended.
All lights flashing
The print head is locked.
An error has occurred.
—
Ink cartridge chip error.
Response
Change the setting in the printer driver, or load
different-size paper.
Install ink cartridges or lower the ink lever.
Make sure the maintenance tank is fully inserted.
Load the paper correctly.
Run the head cleaning utility again.
Open the top cover and remove the uncut paper.
Reload paper if necessary.
Reinstall or replace the cutter blade if necessary.
Reload paper, making sure the edges are straight.
Remove any printouts or paper remaining in the printer
and load more paper correctly.
If the message appears during a print job, reset the
printer by pressing the
Then load paper and resend the job.
Replace the ink cartridge with a genuine Epson ink
cartridge.
Close the rear cover.
Remove the jammed paper. See the Printer Guide for
more information.
If you are using cut sheets, make sure the paper is flat.
Move the paper lever. Then reload paper.
Insert the sheet further into the printer.
Remove the thick paper and move the paper lever out
to the secured position. Head cleaning automatically
starts. After cleaning, reload paper.
Remove the paper.
Replace the conversion cartridge with a new one, or
complete the replacement of the black ink by pressing
the
Replace the expended ink cartridge with a new one.
Remove the protective materials and pull the green
tab on the left side of the print head to release the
print head.
Turn the printer off and unplug the power cable. Let
the printer sit for a while, then try reconnecting the
power cable and turning the printer back on. If this
message appears on the LCD again, note the error
number and contact Epson.
Remove and reinstall the ink cartridge. If the message
remains, replace the cartridge.
12/07
Epson Stylus Pro 4880
pause button for 3 seconds.
pause button.
5
Печатать страницу