Cisco Meraki CW9162I-MR Руководство по установке оборудования - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Беспроводная точка доступа Cisco Meraki CW9162I-MR. Cisco Meraki CW9162I-MR 23 страницы.

Печатать страницу

Pre-Install Preparation

You should complete the following steps before going on-site to perform an installation.

3.1 Configure Your Network in Dashboard

The following is a brief overview only of the steps required to add an CW9162I-MR to your network.

For detailed instructions about creating, configuring and managing Meraki wireless networks, refer to

the Meraki Cloud Controller Manual (meraki.com/library/product).

1. Login to

http://dashboard.meraki.com.

2. Find the network to which you plan to add your APs or create a new network.

3. Add your APs to your network. You will need your Meraki order number (found on your invoice

if you ordered directly from Meraki) or the serial number of each AP, which looks like Qxxx-

xxxx-xxxx, and is

found on the bottom of the unit. You will also need your Enterprise Cloud Controller license key,

which you should have received via email from [email protected].

4. Go to the map / floor plan view and place each AP on the map by clicking and dragging it to the

location where you plan to mount it.

3.2 Check and Upgrade Firmware

To ensure your CW9162I-MR performs optimally immediately following installation, Meraki recommends

that you facilitate a firmware upgrade prior to mounting your CW9162I-MR.

1. Attach your CW9162I-MR to power and a wired Internet connection. See p. 19 of this

Hardware Installation Guide for details.

2. The CW9162I-MR will turn on and the Power LED will glow solid orange. If the unit does not

require a firmware upgrade, the Power LED will turn white within thirty seconds.

* If the unit requires an upgrade, the Power LED will begin blinking orange until the upgrade is

complete, at which point the Power LED will turn solid white. You should allow about an hour for

the firmware upgrade to complete, depending on the speed of your internet connection.

3.3 Check and Configure Firewall Settings

If a firewall is in place, it must allow outgoing connections on particular ports to particular IP

addresses. The most current list of outbound ports and IP addresses can be found here:

http://tinyurl.com/y79une3

If this is your first time, create a new account.