Cisco Meraki CW91641-MR Руководство по установке оборудования - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Беспроводная точка доступа Cisco Meraki CW91641-MR. Cisco Meraki CW91641-MR 23 страницы.
Печатать страницу
3
Pre‐Install
Preparation
You should complete the following steps before going on‐site to perform an installation.
3.1
Configure Your Network in Dashboard
The following is a brief overview only of the steps required to add an CW9166I‐MR, CW9164I‐MR to your
network. For detailed instructions about creating, configuring and managing Meraki wireless networks,
refer to the Meraki Cloud Controller Manual
1. Login to
http://dashboard.meraki.com.
2.
Find the network to which you plan to add your APs or create a new network.
3. Add your APs to your network. You will need your Meraki order number (found on your invoice if
you ordered directly from Meraki) or the serial number of each AP, which looks like Qxxx‐xxxx‐xxxx,
and is
found on the bottom of the unit. You will also need your Enterprise Cloud Controller license key, which
you
should have received via email from [email protected].
4. Go to the map / floor plan view and place each AP on the map by clicking and dragging it to the
location
where you plan to mount it.
3.2
Check and Upgrade Firmware
To ensure your CW9166I‐MR, CW9164I‐MR performs optimally immediately following installation, Meraki
recommends that you
1. Attach your CW9166I‐MR, CW9164I‐MR to power and a wired Internet connection. See p. 19 of
this Hardware Installation
2. The CW9166I‐MR, CW9164I‐MR will turn on and the Power LED will glow solid orange. If the unit does
not require a firmware
* If the unit requires an upgrade, the Power LED will begin blinking orange until the upgrade is
complete, at which point the Power LED will turn solid white. You should allow about an hour for the
firmware upgrade to complete, depending on the speed of your internet
3.3
Check and Configure Firewall Settings
If a firewall is in place, it must allow outgoing connections on particular ports to particular IP
addresses. The most current list of outbound ports and IP addresses can be found here:
http://tinyurl.com/y79une3
8
(meraki.com/library/product).
If this is your first time, create a new
facilitate a firmware upgrade prior to mounting your CW9166I‐MR, CW9164I‐MR.
Guide for details.
upgrade, the Power LED will turn white within thirty seconds.
account.
connection.